Creators: earn 10% per sale. Join the affiliate program
top of page
  • Twitter
  • Instagram
Search

Well Pump Power Outage: How to Get Water Without Power

Nov 11
9 min read

Updated: 6 days ago

Quick answer: If your home runs on a private well, a power outage usually means no running water, because the well pump is electric. Before the lights go out, store at least 1 gallon of water per person per day (FEMA suggests a two-week supply if you can) plus extra for flushing. During the outage, don't drain the plumbing for convenience, flush toilets with a bucket, use the water heater tank as backup drinking water, and only run the pump from a generator that is sized for it and connected through a transfer switch. When power comes back, run the taps for a few minutes, and test the water if the system lost all pressure or the wellhead flooded.

More than 43 million Americans, about 15 percent of the country, get their drinking water from a private well, according to the U.S. Geological Survey. City water usually keeps flowing in a blackout because the utility pumps it. A well doesn't. When the power drops, the pump stops, and the only water left is whatever sits in your pressure tank and pipes.

This checklist covers what to do before, during, and after a well pump power outage, with the steps taken from CDC, FEMA, Health Canada, CPSC, and well-industry guidance.

Why Well Owners Lose Water When the Power Goes Out

A typical well system has three parts: a pump in or above the well, a pressure tank, and the household pipes. The pump pushes water into the pressure tank, and the tank keeps the pipes pressurized so water comes out when you open a tap.

With no electricity, the pump can't refill the tank. You get a limited amount of stored water, then the faucets sputter and stop. Health Canada puts it plainly: your system "may have several litres of water in storage," but using it during the outage depressurizes the system and raises the chance of contamination, because pressure is what keeps contaminants out.

That's why well owners need a water plan that doesn't depend on the tap at all.

What stops working when the pump stops

  • Faucets and showers: they run until the pressure tank is empty, then stop.

  • Toilets: each toilet flushes once from its tank, then won't refill.

  • Water treatment: UV lights, softeners, and other powered treatment equipment stop working.

  • Hot water: an electric water heater stops heating, but the tank still holds water (more on that below).

Before the Outage: Well Pump Power Outage Checklist

Do these now, while the power is on. Most of them take an afternoon.

1. Store drinking water for every person

Ready.gov says to store at least one gallon of water per person per day for several days, for drinking and sanitation. FEMA's Food and Water in an Emergency guide goes further and suggests a two-week supply for each family member if you can manage it. Children, nursing mothers, sick people, and anyone in hot weather may need more.

Use commercially bottled water or clean, food-grade containers. Ready.gov says to replace water that wasn't commercially bottled every six months. For exact numbers for your household, use our guide on how much water to store for a family emergency.

2. Store separate water for flushing

Drinking water is only part of the problem. A toilet built to the current federal standard uses up to 1.6 gallons per flush, according to the EPA. Older toilets can use far more. Flushing is where well households run out of water fastest.

Keep flush water apart from drinking water. Rain barrels, filled bathtubs, and large utility containers all work for flushing, but don't drink from them. A sturdy carry bucket like the Rothco Canvas Water Bucket makes it easier to move flush and wash water from storage to the bathroom.

3. Have a backup toilet plan

If the outage runs long or your flush water runs low, you'll want a toilet that doesn't need water. A Rothco Portable Camp Toilet, a folding steel-frame seat used with waste bags, gives your household a no-water option without wasting what you've stored. Our step-by-step guide to the 2-bucket emergency toilet covers bags, cover material, and disposal.

4. Learn your system before you need it

  • Find the breaker for the well pump in your electrical panel and label it.

  • Find the main shutoff valve and the water heater's cold-water inlet valve and drain valve. FEMA's guide says every family member should know how to close the main valve. Our post on how to shut off gas, water and power walks through each one.

  • Write down the name and phone number of a licensed well contractor. The National Ground Water Association recommends having your well inspected by a certified contractor after severe winter storms.

5. Decide on backup power, the right way

A generator can keep the pump running, but it has to be sized and connected correctly. The wellcare® Hotline from the Water Systems Council says a submersible well pump typically requires a generator of at least 3,500 watts, and bigger pumps need more. The CDC says a licensed well contractor, electrician, or power company should determine the generator size to avoid damaging the pump.

Most well pumps are hardwired, so you can't just plug them into a portable generator. The Red Cross says to have an electrician install a power transfer switch if you want to connect a generator to house wiring. Plan this before storm season, not during the outage.

6. Put light where you'll need it

Pressure tanks and pump controls tend to sit in basements, crawlspaces, and well houses. A hands-free light like the Rothco Cree LED Headlamp lets you read gauges, open valves, and carry water at night with both hands free.

During the Outage: What to Do Step by Step

  1. Stop using the taps for convenience. Health Canada advises against opening faucets, taking showers, or flushing toilets during a power outage, because drawing down the system depressurizes it and raises the contamination risk. Switch to stored water right away.

  2. Drink stored water first. Open your bottled or stored drinking water. Ready.gov says never to ration drinking water unless authorities tell you to. Drink what you need today and look for more for tomorrow.

  3. Flush with a bucket. Pour stored flush water straight into the toilet bowl to flush. That way the toilet doesn't try to refill from the well system. Plan on roughly as much water as the toilet normally uses per flush, up to 1.6 gallons on a standard toilet.

  4. Know your hidden water sources. FEMA lists the water in your hot-water tank, your pipes, and ice cubes as safe hidden water sources. It says not to use water from toilet tanks or bowls, radiators, waterbeds, or pools and spas for drinking.

  5. Tap the water heater only if needed. FEMA's steps: make sure the electricity or gas to the heater is off, close the cold-water intake valve at the tank, open a hot-water faucet to let air in, then open the drain at the bottom and catch the water in clean containers. Let sediment settle. Refill the tank before you turn the power or gas back on, and remember that if the gas was turned off, a professional will need to turn it back on.

  6. Run a generator only outside. The CPSC says to use portable generators outside only, at least 20 feet from doors, windows, and vents, and never in a home, garage, crawlspace, or shed, even with the doors open. Install battery-operated or battery-backup carbon monoxide alarms.

  7. Never backfeed. CPSC warns never to power house wiring by plugging a generator into a wall outlet. Backfeeding can electrocute utility workers and neighbors on the same transformer.

  8. Watch for freezing. In winter, a well house or crawlspace with no heat can freeze. Our winter power outage checklist covers keeping pipes and people warm safely.

After the Power Comes Back

The outage isn't really over until you know the water is safe.

Flush the lines

When power returns, let the tap water run for a few minutes to clear stagnant water from the lines. Both the wellcare® Hotline and Health Canada recommend this. If you have a treatment system, check that it restarted and works properly.

Check whether the system lost pressure

The CDC gives a simple check: turn on a faucet and see if water comes out. If the water spurts on and off because of air escaping, the well and household plumbing lost pressure. If that happened, the CDC says not to drink the water until it's been tested, at minimum for bacteria.

Health Canada also says to test before using the water if the system lost all of its pressure or no water came out of the faucets.

When to test and disinfect

Test the water and don't drink it until you know it's safe if:

  • the system lost all pressure,

  • the water looks, smells, or tastes different,

  • floodwater reached the wellhead, or

  • the well or its wiring was damaged.

After a flood, Health Canada says not to turn the well pump on, because wet or damaged equipment can cause electric shock. Have a licensed contractor inspect the well first. The CDC's well disinfection guidance says wells should be disinfected by a well or pump contractor for safety reasons. It also says to wait at least 7 to 10 days after disinfection before testing, to test for total coliform and E. coli or fecal coliform, and to boil the water or use another source until the results come back. Water contaminated with fuel or toxic chemicals can't be made safe by boiling or disinfection.

If you're told to boil, our guide to boil water advisories vs do not drink notices explains the difference and what each one means for cooking, brushing teeth, and washing dishes.

Well Outage Water Budget (Example)

This is an example for a family of four using Ready.gov's 1 gallon per person per day and EPA's 1.6 gallons per standard flush. Adjust it for your household, climate, and toilets.

Need

Per day

3 days

14 days

Drinking and basic sanitation (4 people x 1 gal)

4 gal

12 gal

56 gal

Toilet flushing (4 flushes x 1.6 gal)

6.4 gal

19.2 gal

89.6 gal

Total

10.4 gal

31.2 gal

145.6 gal

The flushing row assumes you flush only when needed. Every flush you replace with a no-water backup toilet saves up to 1.6 gallons for drinking and cooking.

Printable Well Pump Power Outage Checklist

  • At least 1 gallon of drinking water per person per day stored (aim for 14 days)

  • Separate flush water stored and labeled "not for drinking"

  • Bucket for carrying flush water

  • Backup toilet and waste bags

  • Well pump breaker labeled

  • Main shutoff and water heater valves located and tested

  • Headlamp and spare batteries by the pressure tank

  • Licensed well contractor's number written down

  • Generator sized by a pro and connected through a transfer switch (if you use one)

  • Battery CO alarms installed

  • After the outage: run taps, check for spurting, test if pressure was lost

FAQ

Why don't I have water when the power goes out?

Your well pump runs on electricity. When the power goes out, the pump stops and can't refill the pressure tank, so you only get the small amount of water already stored in the tank and pipes.

How long will my pressure tank last without power?

Not long. Health Canada says a well system may hold several litres of stored water, and the exact amount depends on your tank. Health Canada also advises against using it during an outage because depressurizing the system raises the contamination risk. Plan on stored water instead.

Is my well water safe after a power outage?

Often it is, but check first. Run the taps for a few minutes when power returns. If the water spurted from air in the lines, the system lost pressure, or the water looks or smells different, the CDC and Health Canada say to have it tested before drinking.

What size generator do I need for a well pump?

The wellcare® Hotline says a submersible well pump typically needs at least a 3,500-watt generator, and larger pumps need more. The CDC recommends having a licensed well contractor, electrician, or power company size it, and the Red Cross says permanent connections need a transfer switch installed by an electrician.

How do I flush the toilet when the well pump is out?

Pour stored water directly into the toilet bowl. A standard toilet uses up to 1.6 gallons per flush, according to the EPA. To save water, use a backup toilet with waste bags for most trips.

Can I drink the water in my water heater?

FEMA lists water heater water as a safe hidden source. Turn off the heater's power or gas first, follow FEMA's draining steps, let any sediment settle, and refill the tank before turning the heater back on.

Sources

Rothco Canvas Water Bucket in olive drab with carry handle

Get the Rothco Canvas Water Bucket

Price: $16.99 at Prepper Shop. Ships to the lower 48 states + DC.

Get Ready Now: Shop Emergency Disaster Products

Stock up on essential emergency supplies today — food, water, shelter, and more. Be ready for anything.



 
 
 

Comments


bottom of page